NCS-3230 Rev C Instruction Manual
Copyright © 2003, 2004 New Communications Solutions, LLC
14
6 Multi-Rx
TM
Specifications
F
ront Panel Controls and Indicators
•
MUTE ALL Switch - Mutes all audio unconditionally.
•
POWER Switch - Paddle Switch with Yellow Power Indicator LED
•
Radio Selection Switches – Red LEDS light up when radio selected
Normal
Mode
Top Row – Left Speaker
Bottom Row – Right Speaker
Spatial
Mode
Top Row – Positions Radio(s) in Audio Field
Bottom Row – Centers Radio(s) in Audio Field
•
BUSY Lights – Green LED(s) Flash with audio from corresponding radio(s).
•
RECORD SELECT – Selects radio(s) for recording. Yellow LED indicators.
•
BALANCE and VOLUME Controls – Control Left/Right speaker balance and
volume of both channels.
•
MAN/VOX – Controls manual or VOX operation of record function.
•
RECORD ENABLE – Enables recording. When off (out), no recording can
occur.
•
RECORD ON LED – Lights when recorder is running.
•
MODE Switch – Determines
Normal
(out) or
Spatial
(in) mode.
•
SPEAKERS – Turns speakers off (out) and on (in).
•
PHONES Connector – ¼ in (6.4 mm) stereo phone jack
R
ear Panel Connections
•
AUDIO IN – Inputs from speaker jacks on radios. Approx 150mV required to
light BUSY LEDs.
•
MIXER OUT – Line level outputs from internal mixers for both channels.
•
AMP IN – Line level input to internal audio amplifier, both channels.
•
SPEAKER OUT – Connect 4-16 Ohm speakers to these jacks.
•
DATA – Selective Mute Inputs and Serial Data In /Out
•
RECORDER
AUDIO – Line level audio output to recorder.
CNTRL – start/stop control of recorder. Dry relay contact, isolated from
ground.
•
MUTE – RCA phono jack. When logic low (~0VDC) mutes all audio except
those programmed as Selective Mute.
•
PWR – Coaxial, 2.1mm pin, 5.5mm shell, center pin positive
Power Requirements:
12-15 VDC @ 200 mA average, 1A peak.
Size:
Approximately
8.3 x 6.2 x 3.3 inches
