LabLynx User Manual Revision 1.1 2/18/2021
27
On/Off Push Button
Press and release the button to turn LabLynx on/off. The status LED will light blue when
turning on and change to green after connecting to Cheetah. The status LED will turn off
when the LabLynx is turned off.
Manufacturing Access Panel
Please contact Neuralynx support prior to removing hatch or updating LabLynx
firmware.
LabLynx firmware is stored on a microSD card that is inserted at this location. To
remove the microSD card access cover, unscrew the 0-80 socket head screw and carefully
remove the cover.
Battery Charger
A mini-USB connector is used as the battery charging interface. To achieve optimal
charge rate, use the provided charging cable. The LabLynx can be operated while the
batteries are being charged. The provided charging cable creates a grounded
mini-USB interface. If the provided charging cable is not used to charge batteries while
device is in operation, AC power will induce noise.
LabLynx can charge from a PC USB interface, but at a much slower rate. When charging
from a PC USB interface, LabLynx will likely deplete the battery faster than the battery
can charge.
Battery Charge Indicator
When charging, the battery charge indicator will light red. When charging is complete,
the charge indicator will turn off. If no mini-USB charger is connected, the battery charge
indicator is off.
Back Panel Mounting Locations
To mount the LabLynx enclosure to a ceiling, cage, or a Gimbal mechanism (to act as a
commutator), there are four available 4-40 tapped holes on the back panel of the
LabLynx. These holes are centered on the midline of the enclosure and spaced 1” x 3.5”
apart in a rectangle pattern.
