Doc #: 60-00118 Rev. A
17
To mount the Lucid
™ TCD system on the back of the cart pole, install the Rear VESA Mount Kit
approximately 5
inches below the top cap. Reference the manufacturer’s instructions (included in
the Rear VESA Mount Kit). Install the quick release plate on the Rear VESA mount using 4 x M4
(6mm) bolts.
Remove the four (4) bolts from the Lucid
™ M1 System VESA cover; place the four (4) bolts
aside. Leaving the VESA cover in place, use the four (4) bolts to mount the quick release adaptor
plate (30-00321) to the back of the Lucid
™ M1 System. Use the four (4) M4 x 6mm bolts to
install the quick release mount to the back of the adaptor plate. Verify the Lucid
™ M1 System is
firmly seated on the VESA mount and all four (4) bolts are securely installed. Slide the system
into the installed quick release plate.
Slide the Lucid
™ M1 System on to the Quick Release Plate
Connect the transducers, remote and AC adapter as instructed in this manual. The keyboard and
mouse may be installed by connecting them to the USB ports located on the side of the system.
Place the keyboard and mouse on the Cart tray. Adjust the height as needed. Connect the
external monitor to the Lucid
™ M1 system using the HDMI cable provided in the Lucid™ Cart
Mounting Accessories Box (NA-ACC9).
The External Monitor and Lucid
™ M1 System are only compatible with the HDMI cable
provided in the Lucid
™ Cart Mounting Accessories Box. Other HDMI cables should not be used
with the system
.
