6
Plug-in and Boot Up
1. Plug the power cord from each monitor into a power outlet.
2.
Connect the power connector from the AC adapter to the 9VDC port on the Remote Unit. Make sure the
power connector goes into the port all the way. Plug the AC adapter into a power outlet. The yellow LED
on the RJ45 connector on the Remote and Local Units should illuminate, indicating that a proper power
connection has been made to both. (See Fig. 4.)
Note: The Local Unit is powered by the Remote Unit.
Figure 4- Connect the AC adapter to the Remote Unit
3. Turn ON the CPU and monitors. They should each react as if they were directly connected to each other.
Video Quality
Adjust the Video Quality
It is possible that on initial startup the image on the monitor will not be as crisp as the image normally is. This is
due to the frequency characteristics of the CAT5 cable. It may be necessary to press the "+" or "-" buttons
(see Fig. 5) until the image is crisp and clear. Press the "+" button if the image is not crisp and clear enough.
Press the "-" button if the image has been over-corrected (such that horizontal lines appear to trail or shadow at
the edge of an open window). A momentary press of either button will make a minor change in the image. If
either button is pressed and held, the changes made will be gradual and continuous. Ultimately, the image
quality should improve to a satisfactory level. Once the adjustment is made, it should not be necessary to
change it again as the new settings are stored in memory and become the default settings with each startup.
Video Quality
Plug-in and Boot Up
9 V D C
A d a p t e r
A D A P T E R
B a r r e l
( I n s i d e
b a r r e l )
( O u t s i d e
b a r r e l )
P o w e r C o n n e c t o r
2 . 1 m m x 5 . 5 m m F e m a l e
9 V D C @ 1 . 5 A O U T P U T
Y e l l o w P o w e r L E D
R e a r V i e w o f R e m o t e U n i t
