5
5. Data Report
Data report configuration and sending period are as following:
Min Interval
(Unit:second)
Max Interval
(Unit:second)
Reportable Change
Current Change
≥
Reportable Change
Current Change
＜
Reportable Change
Any number between
1~65535
Any number between
1~65535
Can not be 0
Report
per Min Interval
Report
per Max Interval
The device will immediately send a version packet report and the vibration report data
The device sends data in the default configuration before any configuration is done.
Default setting:
MaxTime: Max Interval = 60 min = 3600s
MinTime: Min Interval = 60 min = 3600s
BatteryVoltageChange: 0x01 (0.1V)
R718DB trigger:
When any way of the sensor senses the vibration and the spring deforms, an alarm message willbe reported.
The vibration is “1”.
No vibration is “0”.
The vibration Restore Configuration:
The Restore function is used to send the final static status of the device.
(Please refer to the configuration command format below.)
Restore = 0, no data will be sent when the device is rest.
The data is sent with the next report.
Restore = 1, the data will be sent with a vibration bit-- 0 after the device is rest for 5 seconds.
Note:
The device report interval will be programmed based on the default firmware which may vary.
The interval between two reports must be the minimum time.
Please refer Netvox
LoRaWAN Application Command document
and
Netvox Lora Command Resolver
