8 | Netstor
Enclosure Setup
2.2 Enclosure Setup
1.
Remove the 6Gb/s SAS JBOD enclosure from its packaging, and place the enclosure next
to desktop PC, server, or workstation.
2.
Hold one of the drive trays from the enclosure and push its button leftward for the release
of the lever until the lever pops out.
3.
Place a drive tray on a flat and level surface, and then attach the hard disk drive into the
drive tray.
WARNING:
You must verify the heads of the four screws are level with the drive tray while the trays are
attached to the hard disk drives; otherwise, a screw could take hold of the tray from the
bottom side and prevent you to pull the drive tray out of the array.
4.
Adopt four of the screws provided, and fasten the tray on the hard disk drive. Tighten
each screw to fasten the drive tray snugly to the hard disk drive. Do not tighten the
screws overly.
WARNING:
Do not force the levers to close while you insert drive modules into the 6Gb/s SAS JBOD
enclosure. If a lever does not close smoothly, draw out and insert the drive module again, and
then press the lever to close.
