NETGEAR WG302 - 802.11g ProSafe Wireless Access Point, Справочное руководство

Страница: 58 / 128

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
4-2 Management
July 2005 v3.0
• Private Community Name : The community string to allow the SNMP manager to read and
write the wireless access point's MIB objects. The default is private.
• IP address to Receive Traps : The IP address of the SNMP manager to receive traps sent from
the wireless access point. The default is 0.0.0.0.
Using the Secure Telnet Interface
The WG302 includes a secure Telnet command line interface (CLI). You can access the CLI from
a secure Telnet client over the Ethernet port or over the serial console port.
.
How to Use the CLI via the Console Port
1.
Using the null-modem cable, connect a VT100/ANSI terminal or a workstation to the
port labeled Console.
If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure
terminal-emulation program.
2.
Configure the terminal-emulation program to use the following settings:
• Baud rate: 9,600 bps
• Data bits: 8
• Parity: none
• Stop bit: 1
• Flow control: none
These settings appear below the connector on the back panel.
Note: You must use a secure Telnet client such as Absolute Telnet. Also, when you
configure the client, use the SSH1, 3DES option. If you use the Telnet client to connect
over the Ethernet port, use the IP address of the WG302 as the host name.