NETGEAR VNB4000-111PAS, Руководство пользователя

Страница: 14 / 69

Installation Overview
Set up your FlexPower system in the following order:
1. Install the base station in your network (see Install the Base Station in Your Network on page 14).
2. Add one or more cameras to the base station by synchronizing them with the base station (see
Synchronize a Camera With the Base Station on page 15).
3. Discover the base station in your network, access the base station for the first time, create a new
password, and perform the initial setup (see
Access the Base Station for the First Time on page 16).
4. Add one or more cameras to an ONVIF-compliant VMS (see Add a Camera to an ONVIF-Compliant
VMS on page 17).
Make sure that the VMS can access a storage device in your network so that you can
store and replay the camera video feeds. If no storage device is available, you can
only take snapshots but not play video feeds. Note
5. Place the camera or cameras at their permanent locations (see Place a Camera for Optimal Motion
Detection on page 19).
6. Access and test the base station camera feeds (see Access and Test the Base Station Camera Feeds
on page 21).
After you complete the setup, you can configure and customize the settings for the base station (see Manage
Base Station Settings on page 23) and cameras (see Manage Camera Settings on page 43).
Install the Base Station in Your Network
You must install the base station in your network. By default, the DHCP client of the base station is enabled,
allowing a DHCP server or router in your network to assign an IP address to the base station. If you want
to assign a static IP address, see
Assign a Static IP Address to the Base Station on page 30.
Install the System Components and Access the Base Station
14
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual