To install the base station in your network:
1.
Connect one end of the Ethernet cable that came in the package to the base station and connect the
other end to a router or switch in your network.
2.
Connect the power cord that came in the package to the base station and plug it into an electrical outlet.
3.
Press the Power button on the back panel of the base station.
After the base station boots, the Power LED and the Network LED light solid green. This process might
take several minutes.
Synchronize a Camera With the Base Station
You must install the base station in your network before you can add a camera to (that is, synchronize a
camera with) the base station.
To synchronize a camera with the base station:
1.
Bring the camera within 2 to 4 feet (60 to 120 cm) of the base station.
After you synchronize the camera with the base station, you can place the camera at its permanent
position.
2.
Press the SYNC button on the front panel of the base station for about two seconds and release the
button.
Install the System Components and Access the Base Station
15
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
