NETGEAR GSM7352S - ProSafe Switch - Stackable, Руководство пользователя

Страница: 619 / 628

Appendix B. Configuration Examples | 619
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
802.1X Example Configuration
This example shows how to configure the switch so that 802.1X-based authentication is
required on the ports in a corporate conference room (1/0/5 - 1/0/8). These ports are
available to visitors and need to be authenticated before granting access to the network. The
authentication is handled by an external RADIUS server. When the visitor is successfully
authenticated, traffic is automatically assigned to the guest VLAN. This example assumes
that a VLAN has been configured with a VLAN ID of 150 and VLAN Name of Guest.
1. From the Port Authentication screen, select ports 1/0/5, 1/0/6, 1/0/7 and 1/0/8.
2. From the Port Control menu, select Unauthorized.
The Port Control setting for all other ports where authentication is not needed should
Authorized. When the Port Control setting is Authorized, the port is unconditionally put in
a force-Authorized state and does not require any authentication. When the Port Control
setting is Auto, the authenticator PAE sets the controlled port mode
3. In the Guest VLAN field for ports 1/0/5 - 1/0/8, enter 150 to assign these ports to the guest
VLAN.
You can configure additional settings to control access to the network through the ports.
See
“Port Security Interface Configuration” on page 6-486 for information about the
settings.
4. Click Apply .
5. From the 802.1X Configuration screen, set the Port Based Authentication State and Guest
VLAN Mode to Enable, and then click
Apply (See “Port Security Configuration” on
page 6-484 ).
This example uses the default values for the port authentication settings, but there are
several additional settings that you can configure. For example, the EAPOL Flood Mode
field allows you to enable the forwarding of EAPoL frames when 802.1X is disabled on
the device.
6. From the RADIUS Server Configuration screen, configure a RADIUS server with the
following settings:
• Server Address: 192.168.10.23
• Secret Configured: Yes
• Secret: secret123
• Active: Primary
For more information, see “RADIUS” on page 6-433 .
7. Click Add .
8. From the Authentication List screen, configure the default List to use RADIUS as the first
authentication method (See
“Authentication List Configuration” on page 6-443 ).
This example enables 802.1X-based port security on ProSafe® Managed Switches and
prompts the hosts connected on ports g5-g8 for an 802.1X-based authentication. The switch
passes the authentication information to the configured RADIUS server.