Model FB104 100 Mbps Network Starter Kit Installation Guide
1.
Set the hub on a flat surface or mount it on a wall and choose a location that is close to
an electrical outlet, exposes the front and rear panels to allow connection of the network
cables and easy monitoring of the LEDs, and places the hub and PCs close enough to
connect the network cables.
To install the hub on a wall, measure the distance between the mounting holes at the back of
the hub and partially screw two 5/16-inch diameter flathead screws (provided) into the wall.
Slide the hub down onto the screws.
2.
Turn on power to the hub by connecting the power adapter.
3.
Verify that the Pwr (power) LED is on.
If the Pwr LED is not on, the hub is defective and should be returned to your point-of-sale
representative.
4.
Make sure that the Normal/Uplink push button is set to Normal.
Set the push button to Uplink only if port 4 is connected to another hub for expansion
purposes.
Install the Hub
Link/Rx LED
(On when link between hub port
and connecting port is good; blinks
when incoming data is on hub port)
Part LED
(On when excessive collisions
or jabber conditions cause
port to be partitioned)
Pwr LED
(On when power is
supplied to hub)
RJ-45 ports
Normal/Uplink push button
(Normal position when
connected to a PC)
Col LED
(Blinks when data
collision occurs on
hub; occasional
collisions are normal)
Ground clip
(Not used)
Power adapter
receptacle
8089FA
Содержание FB 104
Страница 1: ......
