NTC-402
–
Telstra Private IP WAN Configuration Guide
5 of 11
CG01068 v. 1.0 October 2018
© NetComm Wireless 2018
Configuration Procedure
Enable SIM and Log in
Please follow below steps to set up IP WAN on your NTC-402 router.
1
Connect the NetComm Wireless NTC-402 router via the following steps:
a
Use a small Phillips screwdriver to remove the two screws securing the metal plate covering the two
SIM slots on the front of the router.
b
Insert your Telstra SIM card (until you hear a click) into one of the SIM slots found at the front of the
router.
c
Connect an RJ45 networking cable to the LAN port of the router.
d
Connect the other end of the RJ45 networking cable to a port on your computer.
e
Plug in the router
’s
power cord and turn on the power switch at the power point.
f
Wait approximately 1.5 minutes for the router to power up.
2
Log on to Web interface from a web browser:
a
URL address is:
http://192.168.20.1
b
Username is:
root
c
The Password can be foun
d printed on the router’s label and on the last page of the
Quick Start
Guide
.
Figure 1
–
Log in screen
d
Click the Login > button.
