NetApp CN1610, Справочник команд интерфейса командной строки

Страница: 35 / 708

32 Network Interface Commands
network protocol
This command specifies the network configuration protocol to be used. If you
modify this value, change is effective immediately. If you use the
bootp
parameter, the switch periodically sends requests to a BootP server until a
response is received. If you use the
dhcp
parameter, the switch periodically sends
requests to a DHCP server until a response is received. If you use the
none
parameter, you must configure the network information for the switch manually.
network protocol
dhcp
This command enables the DHCPv4 client on a Network port.
The following shows an example of the command.
(CN1610) # network protocol dhcp
network mac-
address
This command sets locally administered MAC addresses. The following rules
apply:
◆
Bit 6 of byte 0 (called the U/L bit) indicates whether the address is
universally administered (b'0') or locally administered (b'1').
◆
Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address
is an individual address (b'0') or a group address (b'1').
◆
The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
Default none
Format
network protocol {none | bootp | dhcp}
Mode Privileged EXEC
Default none
Format
network protocol dhcp
Mode Global Config
Format
network mac-address macaddr
Mode Privileged EXEC