NetApp AltaVault AVA400, Руководство администратора

Страница: 200 / 276

200 NetApp AltaVault Cloud Integrated Storage Administration Guide
Beta Draft
System maintenance AVA-400, AVA-800 Accessing the Service Processor for remote management
Accessing the Service Processor for remote management
The Service Processor is responsible for monitoring sensors, managing the physical environment of the system,
capturing events, logs and forensics, and sending notifications and alerts. It also provides remote management features
for administrators.
Setting the Service Processor password
The Service Processor (SP) is a subcomponent of the controller. There is no password on the Service Processor until
you set the password. The Service Processor password must be set separately from the AltaVault OS administrator
password.
To set the SP password
1. Log in to the CLI using either the serial connection, or an SSH session using the configured primary management
interface set up using the CLI configuration wizard steps. For more information, see
“Using the AltaVault
appliance CLI configuration wizard” on page 17 .
2. Enter configuration mode and set the Service Processor password in the controller using the following CLI
commands:
CLI > enable
CLI # configure terminal
CLI (config) # sp password set
3. Use the new password when logging into the Service Processor.
Note: After the AltaVault appliance is switched over to FIPS mode, the service processor password cannot be set anymore because
of FIPS compliance restrictions. Set the service processor password prior to switching to FIPS mode. If the
sp password set
command is not working, check to see whether the AltaVault appliance is in FIPS mode.
Configuring the Service Processor for remote management
Access to the SP for remote management is accomplished by connecting through the serial console port or via SSH to
the IP address of the Service Processor, after the SP is configured with an IP address and password.
Before you begin

Ensure that you have serial console access to the AltaVault appliance.

Set the SP password as described in “Setting the Service Processor password” on page 200 .

Provide an IP address for the SP (if not using DHCP) that is on the same subnet as the primary interface. The SSH
connection to SP is established via the cabling to the Management Port (wrench port) on the AltaVault, and
therefore the IP address assigned to the SP should be in the same subnet as the Management port or be routable to
the Management port on the AltaVault.