Net2Phone XJ100, Руководство пользователя

Страница: 19 / 63

XJ100 Wireless Handset User’s Guide – Chapter 3
11
Setup Overview
Before you can begin using the XJ100, you must first complete
the following configuration procedures:
Network configuration
Wireless configuration
WEP setup (ONLY if your wireless network uses WEP
encryption)
NOTE: Before it is configured, the phone
display will say, “NET Fail!”. This is
normal and will be corrected once the
configuration is complete.
Network Configuration
The first step in setting your XJ100 for use is to configure it
with the appropriate settings for your network. There are two
(2) available network configurations:
DHCP
Static IP
To determine which one you should use, refer to the Network
Settings section of the checklist on page 3 of this Guide. If
you indicated that your network supports DHCP (if you
answered “Yes”), continue with the
Using DHCP section
below. If your network does not support DHCP, skip to the
Using a Static IP Address section on the following page.
Using DHCP
The Dynamic Host Configuration Protocol (DHCP) client
provides a mechanism for allocating IP address dynamically so
that addresses can be reused when hosts no longer need
them.
By default, the phone is configured to use DHCP, so if this
is the mode you will be using, no further configuration is
required
. Skip to the Wireless Configuration section on
page 7 in this Guide.