8
NET145LA/NET145CL User
’s Manual Rev1.0C
© 2004 NET GmbH. All rights reserved
1) Connect one end of the data cable from FG on PC to camera connector.
1-1) Indicates the connector for outputting digital video signal
1-2) Read out 10-bit parallel signal according to EIA-644 or RS-422 specifications.
2) Connect serial cable(RS-232C) from COM Port on PC to camera connector.
(only used in case of NET145LA)
3) Connect one end of the power cable from power supply to camera connector.
3-1) 12VDC power from the external DC power.
3-2) For the power supply voltage, supply the rated 12VDC. If it fluctuates, be sure to use the
voltage within the range 10VDC to 15VDC.
2.6.3 Installation for RS-232 Control Program
1)
Make any folder (ex: NET145) on your PC
2)
Copy the RS-232 control program to your PC
This should correspond to the appearance figure shown below
3)
Program may be different according to the camera model
4)
Run the RS-232 Control Program
5)
Evaluate the serial communication, shutter speed, mode setting, etc.
(Refer to the Serial Command List)