Net.Do FOX512, Руководство пользователя

Страница: 28 / 33

Net.DO
Lighting Control Equipment Co.,Ltd http://www.netdo.com.cn
FOX512 Moving Light Controller. PAGE: 27
9.8.2 Playback Key
In Playback Running menu, press F4 soft key to switch the controlling mode of Playback Key to be
Swop, Flash or LTP output.
Swop --- Only 1 playback can be output at the same time.
Flash --- Press and hold Playback Key , the program will be output; Release to stop it.
LTP output ( * ) --- Output LTP channels in advanced without Dimmer output. Then push up
Playback Fader to output Dimmer.
9.8.3 Use “Playback Menu”
Playback menu is used to set the run parameters of
“Multi-Step Program”. Press TIME/PB key to enter
Playback menu, select program by Playback Key , then
set the speed(Auto1), Run Mode, Start and End way of
the current program. As shown on the right:
 Run Mode
There are 3 modes of Synchronous trigger
to run “Multi-Step Program”;
Auto 1
：
the running of “Multi-Step Program” is controlled by external speed.
(In this mode, all steps will ignore the internal speed and run the external speed.)
Auto 2
：
the running of “Multi-Step Program” is controlled by internal speed.
Music
：
the running of “Multi-Step Program” is triggered by Music rhythm.
TIPS
：
Differences between internal speed and external speed of “Multi-Step Program”:
--- Every “Multi-Step Program” has its own external speed which can be set in Playback Menu,
the pace of all steps in the program will be the same while the program run external speed.
--- Every step of “Multi-Step Program” has its own internal speed, in EditStep menu, internal
speed of each step can be customized individually.
 Start Way
There are 2 ways to start the playback of “Multi-Step Program”:
1 ） fader:
The “Multi-Step Program” will start running when Playback Fader is pushed up from 0.
2 ） GO:
The connected “Multi-Step Program” will start running by pressing GO/STOP key or
corresponding Playback Key . Programs will not start by pushing up Playback Fader.
 End Way
There are 2 ways to end the playback of “Multi-Step Program”:
1
）
Loop:
When “Multi-Step Program” runs to the last step, it will return to the first step and run again.
2
）
Stop:
When “Multi-Step Program” runs to the last step, it will stop until it’s started again.
 Value of external speed (external speed of “Multi-Step Program”)
External speed of “Multi-Step Program” is used for Synchronous trigger in Auto1 . External
speed of current “Multi-Step Program” can be set by A/B Wheel in Playback menu.
External Speed ( Auto1)