8
USER SETTINGS
(User Settings can be programmed by the User at any time without entering Program Mode)
Assigning a PIN to a CARD
If the system is programmed for access is to be granted with “Card and PIN” (Programming Option 32 set) a PIN
for each Card must be assigned using this option. (The Factory Default when cards are first programmed into
the system is PIN 1234)
Press *
Present the Card
to the Reader
Enter Old PIN
(Default 1234)
#
Enter
NEW PIN
#
Repeat the
NEW PIN
#
Assigning a PIN to a ID Number
This option also assigns a PIN to a Card, but if the card is unavailable you can assign it to the User’s ID Number
(Memory slot Number)
Press *
Enter the ID
Number the PIN
will be assigned to
#
Enter
Old PIN
#
Enter
New PIN
#
Repeat the
NEW PIN
#
OPERATION
Unlocking the Door By Card OR PIN
.
If the Door Access Control Setting (Section 6) is programmed to “Card or PIN”, access will be granted by
presenting a valid Card to the Reader or by entering a valid PIN
Either OR
If successful, the LED will flash Green and the Relay will activate for the Unlock time
If unsuccessful, the S2 will sound 3 Beeps and the likely cause will be a non valid Card (unprogrammed or
incorrectly programmed) or incorrect PIN entry (refer to Programming Section 3, “Adding Users”)
If a Card is presented and the LED glows steady S2 is waiting for a PIN to be entered. If this is not intended refer
to Programming Section 6 “Door Access Control Settings” and select the correct Access Setting
Present Card to Reader
Enter 4 Digit PIN followed by #
