3
Programming
0 - Resetting to Factory Defaults
To reset to factory defaults, power off then press and hold the
*
key while powering up. S2 will beep twice and the
LED will glow orange. Release the
*
key and the S2 will be ready for one of the following options:
1)
Presenting the “Add User Master Card” to S2’s Reader to add a new user
2)
Presenting the “Delete User Master Card” to delete a current user
3)
Presenting a blank EM card to replace an “Add User Master Card” or “Delete User Master Card”. In this
case the first blank card presented will become the new “Add User Master Card” and the second blank
card presented will become the new “Delete User Master Card”. The LED will flash Red confirming that S2
has been reset to factory defaults and new Master Cards added. If the new Master Cards are not presented
within 10 seconds S2 will resume User Operating Mode and the LED will glow steady Red
When resetting to factory defaults the user's information is still retained
1 - Entering Programming Mode
(Default Master Code = 888888)
Press *
then enter the
Master Code
followed by
#
(e.g. * 888888 #)
S2 will enter Program Mode, the LED will flash Green for one second and then glow steady Red while S2 awaits
Program Option Commands. To Exit Program Mode press
*
. If no keys are pressed for 60 seconds S2 will
automatically exit Program Mode and resume Operation Mode
The following options can be accessed and programmed in Program Mode
2 - Changing the Master Code
(Master Code must be 6 digits long)
(Can only be done in Master Programming Mode)
Press 0
- The LED will glow Orange. Enter a
New Code
followed by
#
then re-enter the same
New Code
followed
by
#
. The LED will flash Green if successful
Press 0
New Code
#
Confirm New Code
#
Up to 2500 user cards can be added. The first two options are available in Program Mode only and the third is also
available in Operation Mode
3.1 Adding Card Users Automatically in Program Mode
(Not recommended)
Press 1
- The LED will glow Orange.
Present a blank card
to the Reader. S2 will automatically assign the first card
as User Card 1. When successful the LED will flash Green. Repeat this process for all new cards and then press
#
This method is not recommended because S2 will automatically allocate added cards to the next available
empty card slot. This makes it difficult to delete a card as its allocated card slot (ID number) will not be known
3 - Adding Users
(Can only be done in Master Programming Mode)
Press 1
Present Card 1
Present Card 2
Present Card 3
…
#
