Ness Security Products Securityguard III, Руководство по программированию

Страница: 18 / 30

Doc ID. SG3PROG00103_03_2014.DOC 18
RANGE DETECTOR RANGE (default = LOW)
LOW Low range 8m
HIGH
High range 14m
Note: OK light turns on each time PIR is activated.
PULSE
DETECTOR PULSE COUNT (default = 3)
1-4
Number of times (1-4) a detection beam needs to crossed before an alarm occurs
Note: OK light turns on each time PIR is activated.
SIGNAL
SIGNAL CHECK: Check signal strength of radio detectors and keys
SecurityGuard registers the first device received and displays the signal strength (1-9), and
beeps a corresponding number of times.
•
Press ON to activate Signal Check display shows “SEND DEVICE”
•
For a key, press PANIC; for a detector, activate the detector
•
Listen to beeps, view display
•
Press OFF to exit Signal Check
•
Press ON to re-activate Signal Check
-- No detectors received
SENS 2-23
Detector x received
KEY 1-23 Key x received
1-9
Signal strength
Note: OK light indicates main detector trigger
RADJAM RADIO JAMMING (default = OFF)
In the event of a SecurityGuard sensing a continuous (>30 secs) source of Radio Frequency
Interference (RFI), it can generate a CHIME alarm in DISARMED or HOME or HOME 2
modes, and a full alarm in ARMED modes.
ON Enabled
OFF
Disabled
RADSUB
RADIO INTENTIONAL MESSAGE SUBSTITUTION (default = OFF)
In the event of a SecurityGuard sensing a radio message with a recognised device ID but
failing decryption, it can generate a CHIME alarm in DISARMED or HOME or HOME 2 modes,
and a full alarm in ARMED modes.
ON
Enabled
OFF Disabled