NESS ID TECK Finger007, Руководство пользователя

Страница: 15 / 61

101-092 15 FINGER007 – Version 4.0
IDTeck – FINGER007 FINGERPRINT & PROXIMITY READER
z Do not install the reader in areas where sources of broad spectrum EMI noise may be present
examples of EMI broad spectrum noise producers are motors, pumps, generators, AC-DC converters,
uninterruptible power supplies, AC switching replays, light dimmers, computer monitors and CRTs.
5. INSTALLATION
5.1 TEMPLATE
•
Tear off last page and use provided template to drill two 6-32 holes and one ½” hole on the proper location of
the wall to mount the Wall Mount bracket as shown below.
(If the gang box is already installed on the wall then skip this step.)
•
Using 2 screws, install wall mount to the wall.
* CAUTIONS *
Before mounting the NESS - IDTECK FINGER007 unit to the Wall Mount bracket, an operational test of
the unit should be completed, because the locking pins will lock the unit to the Wall Mount. Removing the
unit from the Wall Mount bracket after it has been snapped in place may cause damage to the bracket and
prevent reattachment.
•
Insert 5 O-Rings to the Wall Mount as indicated, then run the cable from the main unit through the center
hole and snap in place the main unit to Wall Mount. Make sure that the main unit is securely locked in place
with Wall Mount.