9
If during RUN mode the shutter is rotated from the
open to the closed position, the LED will blink
indicating the shutter needs to be opened. If the
shutter is not opened within 2 seconds, the machine
will automatically switch from RUN mode to IDLE
mode, and the LED will go out.
NOTE: Remember to close the shutter if the
laminator is set to IDLE and will not be
used within 5 minutes.
SPEED (Motor Speed Adjustment Knob)
The motor speed can be adjusted in a range from 0 to
15 fpm (0 to 4.6 mpm).
Turning the knob clockwise will cause the speed of the
motor to increase.
Turning the knob counterclockwise will cause the
speed of the motor to decrease.
F/R (Forward/Reverse)
The selected Motor Direction Touch Switch controls
the direction of the feed motor, forward (F) and
reverse (R). The LED adjacent to the selector touch
switch indicates the selected direction.
When FORWARD is selected, the feed motor feeds
images through the laminator from front to back.
This direction should be used during normal
laminating operations.
The REVERSE position should only be used to
retrieve jammed images.
R E A R C O N T RO L PA N E L
Figure 8: Rear Control Panel
FUSE
2.5A main power fuse for the laminator.
I/O (Power On/Off Switch)
Controls the laminator main power setting, ON or
OFF.
POWER AC INLET
The power supply cord connects to the Power AC
Inlet.
Power On/Off Switch
Fuse
Power AC Inlet