27
*If there is no gap at all, you may need to move your envelope support wedge in underneath the envelope stack a
little farther, or lower the separator tip a bit to create a more pronounced buckle for better envelope separation.
*If the envelopes do not feed consistently, or the gap between envelopes on the delivery table exceeds 3 or 4
inches, you may need to move the back wedge back a little to let the envelopes contact the feed belts more.
If you have consistent feeding with consistent gaps between envelopes, you are now ready to move the feeder
into position with the printer.
Turn power to the feeder OFF and remove the envelope from the end of the delivery table.
Setting the speed of the feeder
As a general rule, the feeder should be set to run small envelopes (#9, #10, 6x9, etc.) at approximately
70% of maximum (2:00 on the dial)
For larger envelopes, (9x12, 10x13, etc.) set the speed at 100%
As a rule, larger envelopes will require a higher speed setting.
NOTES ON SPEED SETTINGS:
2:00 to 3:00 position for
standard envelopes
Set speed at 100% for
large envelopes
(over 6” long in the running
direction)
