Manuel PLIMOA
9
Replacing the rear wheel:
Take the wheel and place the chain on the small sprocket on the right-hand side, then place the wheel between
the brake pads.
Insert the wheel axle backward into the housing on the left and right of the frame. Attach the washers and the
wheel nuts. Tighten the nuts by hand initially, until they make contact with the frame.
Centre the wheel in line with the frame and the mudguard. Check the centring and positioning in line with the
front wheel, as well as the positioning of the chain.
Screw on the wheel nuts on both sides without tightening them. Check the positioning, centring and position of
the chain again.
Alternately and progressively tighten the wheel nuts on each side (max. tightening torque 30 Nm)
Replace the nut covers.
Reconnect the motor connection and replace the cable tie on the frame.
NB: the connector is equipped with a keyed connection. Place the two pins so that they are facing each other
(follow the arrows).
Adjust the brake pads (see 2.3.1).
2.6 Lights:
Your bike is equipped with:
❖
Front and back fixed lighting. Both front and rear lamps are powered by the battery.
Position the two
pins correctly to
reconnect the
motor plug
