Manuel PLIMOA
8
2.5 Mounting and dismounting wheels (rear wheels by specialist):
2.5.1
Front wheel:
Wrench 15 mm
Removing the front wheel:
First, loosen the V-
Brake’s cable clamp to release the pads and
enable the removal of the wheel. Undo the cap
nuts on each side and remove the washers.
Lift the bike and lightly tap the top of the tyre to remove the wheel.
Replacing the front wheel:
Reposition the washers on the wheel axle. Lift the bike and insert the wheel axle into the base of the opening
of the fork ends.
Check the position of the washers as well as the centring of the wheel. Screw in the wheel nuts. Alternately and
progressively tighten the wheel nuts on each side (max. tightening torque 25 Nm).
If the wheel is not centred, loosen the nuts and start again.
Do not adjust the locknuts, you risk damaging the bearings.
Readjust your brake (
see 2.3.1).
2.5.2 Rear wheel:
This operation should be performed by a professional, but here's what to do
15 mm open-ended spanner.
Removing the rear wheel:
Disconnect the motor (the connector is situated on the right side of the e-bike on the lower horizontal section
of the frame).
Cut the cable tie attaching the motor cable to the frame. Remove the right and left wheel nut covers. Loosen
the nuts. Remove the nuts and the wheel axel washers. Loosen the V-
Brake’s cable clamp to release the pads
and enable the removal of the wheel.
Remove the chain from the wheel sprocket, while paying attention to how the chain swings.
