Instructions for use:
BiliCocoon™ Fixation System
IFU-BCC301-EnFr-2017-04-v03
Page 11
EN
Warning
The BiliCocoon™ Light Box can only be installed on the BiliCocoon™ Fixation System once the pads have been removed from the Light Box. The
pads should only be connected or disconnected when the BiliCocoon™ Light Box is mounted on the BiliCocoon™ Fixation System. Users must
only disconnect or connect the pads while securely holding the Light Box tightly with their hand.
Presentation of the fixation system
Hanging the fixation system
The fixation system consists of a fixation plate (1) with two fixation hooks, as
well as a holding claw (2). Completely unscrew the screw so that the tightening
hinge can be fully opened. If the hinge cannot be fully opened, replace the
fixation system.
Place the tightening hinge on a stable stand (3), so that the hinge can be tightened on
to it. The stand must be stable, solid, vertical and must be between 1 and 5 cm thick.
Then, tighten the hinge by
fully screwing the tightening screw in as far as it will go. The
fixation system must be flush with the stand and must not slide or move.
1
2
3
