Neomatica ADM333 BLE, Руководство по эксплуатации

Страница: 18 / 48

Neomatica LLC. Vehicle tracker ADM333BLE GLONASS/GPS. Ver. 1.2 dd 13.07.2019
18
Drawing of the tracking routes stays a priority. If other conditions for route points record are
not performed then the points will be recorded according to the alarm period.
Such a function allows fixing the moment when sensor values are beyond the acceptable range
as well as recording in more details the values changes outside the allowed range.
⎯
Setting the period of route points record at the alarm mode.
ALARMPERIOD X
X
– period of route points drawing in seconds
Command without parameters shows the set value
5.8 Setting the fixation (freezing) of coordinates during the parking
The margin of error in coordinates determination might cause a slight coordinates dispersion
(GPS drifts) during a long-term parking of the vehicle. To prevent this effect the coordinates freezing
function might be applied in the beginning of the parking. This mode is enabled automatically when
the discrete level is changed at the analog input or when there is no vibration. Location fixation
(freezing) according to the vibration values is chosen by default. It is impossible to use
simultaneously two ways of coordinates fixation. The tracker fixes the coordinates according to the
last mode.
5.8.1 Coordinates fixation according to ignition
To enable the fixation coordinates function when the vehicle ignition is switched off, it is
necessary to connect to the analogue input a circuit being under voltage when the ignition is on.
Activation of this mode and selection of the input are made by the "INSTATIC" command. For
this analogue input it is necessary to activate a discrete working mode and set values range of
the voltage level for the logical
«1» «
INTRUE
» and the logical «0» «
INFALSE
». Then choose
the mode of coordinates fixation according to ignition and a number of the input the ignition is
connected to. In this way, when the ignition is off, an event will be formed at the input and the
coordinates fixation will be initiated.
⎯
Examples of using INSTATIC command:
Coordinates fixation at 0 on input AIN0 INSTATIC 0,0
Coordinates fixation at 0 on input AIN1 INSTATIC 1,0
The function is disabled by « INSTATIC 255» command
5.8.2 Coordinates fixation according to vibration level
In such a mode coordinates fixation is done automatically at the absence of vibration. Current
level of vibration (a sum of acceleration on three axes) is determined by the acceleration meter.