«Neomatica» Wireless sensor-immobilizer ADM33, edition 1.1 dd 11.11.2019
7
4.
Setting and installation order
1.
Select immobilizer working mode;
2.
Select way of connection;
3.
Connect immobilizer to the tracker ADM333 BLE;
4.
Set immobilizer;
5.
Connect to the power supply and secure immobilizer body.
4.1.
Installation order
•
Deenergize power circuit where installation is planned. When installing on a vehicle
switch off “minus” clamp of the accumulator.
•
Place immobilizer in a hard-to-reach place to avoid interaction with moving parts of the
vehicle.
To prevent bad quality of Bluetooth LE radio signal it is not recommended to put
immobilizer into metallic housings, truck body and other massive metal structures. It is
possible to put the immobilizer under plastic panels, housings and other plastic
structures. There is “Antenna” marking on the immobilizer sticker (label), the position
of such marking coincides with the position of the antenna of Bluetooth LE radio
interface. When installing the immobilizer into a cord assembly the antenna should be
placed upwards. Do not install the immobilizer in places where the temperature is equal
to or above the motor operation temperature (pipes of motor cooling system, exhaust
system, etc.).
•
Fix the immobilizer with the help of clamps or cable binders.
•
Connect the immobilizer to power supply (Red cable (+) and Black cable (GND)).
Connect GND cable to main power source or to the truck body. When using
semiconductor switches connect “GND” outlet to the power source that is able to
provide the current used by load connected to “Output 1” and “Output 2”. Maximum
current in the Black cable (GND) must not exceed 2.6 A.
To connect Red cable (+) use the main vehicle power source with steady voltage of 10
V up to 40 V.
