Neogen Corporation Electro Jac 6, Руководство оператора

Страница: 9 / 16

Questions? Call us at 800/621-8829 or 859/254-1221
6
Questions? Call us at 800/621-8829 or 859/254-1221
7
Automatic operation with optional dwell cable
NOTE: Optional accessory (not included in the complete set)
1. To protect the unit and the animal, ElectroJac 6 must be prepared for use prior to
beginning the operation. To prepare the unit:
a. Set the
Auto/manual
switch on the electronics instrument case to
Auto
.
b. Set the
On/off
switch on the dwell control box to
Off
.
c. Set the
Manual
control on the electronics instrument case to
Low
.
d. Plug one end of the probe cable into the electronics instrument case in the port
marked
Probe
(on the case’s right side) and the other end to the probe.
e. Plug the dwell cable into the electronics instrument case in the port marked
Dwell
(on the case’s left side).
2. Once the animal is prepared for collection, insert the probe into the animal’s rectum
with the three brass electrodes facing down.
3. After the probe is in place, set the On/off switch on the dwell control box to On .
ElectroJac 6 will automatically start through 40 cycles (2 seconds on, 2 seconds off)
unless the
Dwell
switch is held down.
4. The red dwell light will glow and the numeric display will indicate the progression
through the unit’s 40 cycles. A glowing dot in the bottom right-hand corner of the display
indicates when power is being delivered to the probe. Once semen collection is com-
pleted, turn the
On/off switch to Off .
5. After use, wipe the probe and cables down with a sponge and a nontoxic, nonabrasive
cleaning solution.
Resetting the unit
If the animal experiences extreme discomfort, the unit may be reset to the lowest power
level at any time by simply setting the
On/off
switch to
Off
. When the unit is turned back on,
it will automatically reset to the lowest power level.
Using the dwell switch
When the dwell switch is pressed, the electronics will remain at the current cycle, and
continue to repeat that power level. When released, it will continue to cycle, starting at the
next power level.
Example
When the animal becomes stimulated, the dwell
button may be depressed. By holding the switch
down, the unit will remain at that level until
ejaculation. Should the animal appear to lose
stimulation, release the switch and the unit will
automatically continue increasing the intensity
of each cycle until the animal again becomes
stimulated.
Dwell light
Dwell switch
On/off switch on
dwell control box