NEO STORMER QUAD, Руководство пользователя

Страница: 8 / 35

P. 8
Neo Stormer Quad - English version
3-Pin / 5-Pin
If you use a controller with a 5 pin DMX output connector, you will need to use a 5 pin to 3 pin adapter.
They are widely available over the internet and from specialty retailers If you’d like to build your own,
the chart below details a proper cable conversion:
Conductor 3-Pin Female (Output) 5-Pin Male (Input)
Ground/Shield Pin 1 Pin 1
DMX Data (-) Pin 2 Pin 2
DMX Data (+) Pin 3 Pin 3
Not Used. No Connection. No Connection
Not Used. No Connection No Connection
Take It To The Next Level:
Setting Up
DMX Control
Step 1: Connect the male connector of the DMX
cable to the female connector (output) on the con-
troller.
Step 2: Connect the female connector of the DMX
cable to the first fixture’s male connector (input).
Note: It doesn’t matter which fixture address is the
first one connected. We recommend connecting the
fixtures in terms of their proximity to the controller,
rather than connecting the lowest fixture number
first, and so on.
Step 3: Connect other fixtures in the chain from
output to input as above. Place a DMX terminator
on the output of the final fixture to ensure best
communication.
Fixture Linking
(Master/Slave Mode)
1. Connect the (male) 3 pin connector side of the
DMX cable to the output (female) 3 pin con-
nector of the first fixture.
2. Connect the end of the cable coming from the
first fixture which will have a (female) 3 pin
connector to the input connector of the next
fixture consisting of a (male) 3 pin connector.
Then, proceed to connect from the output
as stated above to the input of the following
fixture and so on.
A quick note:
Often, the setup for Master-Slave
and Standalone operation requires that the first
fixture in the chain be initialized for this pur -
pose via either settings in the control panel or
DMX IN
DMX IN DMX OUT
First Fixture in
Chain
Next Fixture
in Chain
T
o Next Fixture
DMX IN
DMX IN DMX OUT
First Fixture in
Chain
Next Fixture
in Chain
DMX out