7
SPECIFIC COMMANDS
Each of the energizers can be instructed to obey specific commands. Without
having to go and physically look at an individual energizer it is easier to follow
the following procedure. If only one energizer is required to be in the OFF
state it is far easier to issue a global command and ensure all energizers are
ON by verifying that the GOOD indicator is permanently lit. Issue the specific
energizer OFF command. Verification is then obtained if the GOOD indicator is
now flashing. If only one energizer is required to be in the ON state, do a
global OFF and check that the ON indicator is not flashing or lit. Turn on the
individual energizer and confirmation is obtained if the ON indicator is flashing
or lit. The same methodology can be used with the High-Voltage and Low-
Voltage commands and the ON indicator. (If this process seems cumbersome,
full status and control, of individual energizers is possible with the embedded
Linux platform).
SPECIFIC ENERGIZER ON/OFF
Enter your PIN (master only) and press the
*
key, enter the digits 0 and X,
then press the
#
key. X is the number for the Master or respective Slave unit
and can take on the value as follows: X=1 for the Master unit, X=2 for the
first Slave unit, ditto for the other Slave units up to X=9 for the eight Slave
and X=0 for the ninth Slave.
The GOOD light should flash if one or more energizers are switched off.
SPECIFIC ENERGIZER HIGH/LOW-VOLTAGE
Enter your PIN (master only) and press the * key, enter the digits 3 and X,
then press the
#
key. X is the number for the Master or respective Slave unit
and can take on the value as follows: X=1 for the Master unit, X=2 for the
first Slave unit, ditto for the other Slave units up to X=9 for the eight Slave
and X=0 for the ninth Slave.
The ON light should flash if one or more energizers are in Low-Voltage mode.
MERLIN STEALTH
MASTER
Using your MASTER KEYPAD
