Nemtek Druid LCD 20, Руководство пользователя

Страница: 11 / 17

All keypad codes must end with the # key to enter the code sequence.
If you pause for more than five seconds between key presses, the keypad will produce a
fast beeping sequence and all earlier keys will be deleted.
A correctly entered sequence will be acknowledged with two beeps.
Activating and deactivating the unit _ _ _ _ #
The unit can be activated or deactivated by entering the four digit master PIN (default
master PIN is 1234).
If the fence monitoring is off, the
O symbol under the FENCE label on the keypad will be lit
and on the unit’s LCD, the O symbol linked to the ZONE STATE label will be shown.
If the fence is on, one of the
GOOD , CHECK or BAD indicators on the left of the keypad
will be lit and the unit’s LCD will show GOOD , CHECK or BAD , depending on the fence
condition.
Acknowledging and silencing an alarm condition _ _ _ _ #
Enter the reset PIN (default reset PIN is 5555). The siren will be silenced if not yet timed
out, the internal beeper will stop sounding and the strobe will be deactivated. One of the
alarm , alarm history or event symbols will indicate the source of the alarm.
The above can also be achieved through entering the master PIN, however the unit’s
operating state will be toggled at the same time.
Clearing an alarm or event from memory _ _ _ _ #
An alarm symbol indicates that the condition persists and will have to first be
corrected. An alarm history symbol indicates the fault no longer exists and simply
entering the reset PIN will clear the memory condition. Only if the alarm condition is
resolved will the unit operate without further alarm activation.
The above can also be achieved through turning the unit
Off and On again using the
master PIN.
Using your keypad
11
t
MASTER PIN
MASTER PIN
MASTER PIN