Nemo V2 Divers, Руководство пользователя

Страница: 10 / 16

8
4. Gear speed selection
The gear speed selector (3) can be activated at a standstill.
Two speed ranges can be pre-selected with the gear speed selector (3).
If the gear speed selector (3) cannot be pushed through to stop, lightly turn the drill chuck with the drill.
This is a normal occurrence. This tool has a speed gear clutch, and sometimes the gear teeth hit
together, resulting in the gear speed selector sticking.
Do not push the gear speed selector forcefully when in this condition , as it may break the gears.
5. Switch On and Off
To start the machine, press the On/Off switch (9) and keep it pressed. To switch off the machine,
release the On/Off switch (9).
6. Adjusting the speed
The speed of the switch on power tool can be variably adjusted, depending on how far the On/Off
switch (9) is pressed.
Light pressure on the On/Off switch (9) results in a low rotational speed. Further pressure on the switch
results in an increase in speed.
7. Fully automatic spindle lock (Auto-lock)
When the On/Off switch (9) is not pressed, the drill spindle and the tool holder are locked. This enables
screws to be screwed in, even when the battery is dead, and allows for the machine to be used as a
screwdriver.
8. Motor braking (Dynamic braking)
When the On/Off switch (9) is off, the drill motor brakes to a stop, thus preventing the over spinning of
the tool. When driving in screws wait until the screw is screwed in flush with the material and then
release the On/Off switch (9). By doing so, the head of the screw does not penetrate the material.
9. Temperature dependent overload protection
When using the drill as intended, the power tool cannot be subject to overload.