Nemo V2 Divers, Руководство пользователя

Страница: 11 / 16

9
ADDING AIR PRESSURE TO YOUR DRILL FOR UNDERWATER USE
This Nemo drill may be used in any wet conditions and may be submerged and used underwater at
depths of up to 50m. For
ALL underwater use, it should be pressurized according to the instructions and
table below.
*IMPORTANT: DO NOT ADD MORE THAN 6 BARS OF AIR PRESSURE TO THE NEMO DRILL.
Before storing your Nemo drill, pressure should be released.
Tips
1) For drilling in metal, use only perfectly sharpened HSS (High Speed Steel) drill bits.
2) Before screwing larger, longer screws into hard materials, it is advisable to pre-drill a pilot hole with
the core diameter of the thread to approximately 2/3 of the screw length.
3) Use the proper gear settings, torque settings, and drill bits for different tasks. Please see above.
Depth Necessary Pressure*
Up to 5m Min. 1 Bar
Up to 10m Min. 2 Bar
Up to 20m Min. 3 Bar
Up to 30m Min. 4 Bar
Up to 40m Min. 5 Bar
Up to 50m (MAX.) MAX. 6 Bar
1. Locate the red cap on the back
valve at the back of the drill.
2. Remove the red cap and
connect a pump (for example,
a simple bicycle pump). 3. Pump air / pressure into the
drill, according to the table below:
1. Locate the red cap on the back
valve at the back of the drill.