Nellcor NPB-75, Руководство по обслуживанию

Страница: 14 / 71

4-1
SECTION 4: SERVICE MODE
4.1 Introduction
4.2 Service Level 1
4.3 Service Level 2
4.1 INTRODUCTION
The monitor supports a service mode built into the instrument’s firmware.
To access the service mode, refer to Table 4-1: "Accessing Service Mode
and Changing Parameter Settings".
The architecture of the monitor’s service mode divides the service mode
into two levels as described in the sections below.
• Service Level 1
• Service Level 2
4.2 SERVICE LEVEL 1
The Service Level 1 provides information and tools on three service
screens to test and calibrate specific functions without disassembling the
monitor.
• Information Screen
• Event Messages Screen
• Interface Test Screen
From these display screens the service technician can check the operating
hours counter and event messages, test the Human Interface functions
(HMI), set the light detection threshold, adjust the LCD contrast middle
point and perform a calibration check and a calibration process, if
necessary. Refer to Table 4-1: "Accessing Service Mode and Changing
Parameter Settings".
4.2.1 Information Screen
The information screen displays the monitor’s main board serial number,
the number of operating hours, and the SpO
2
and C O
2
boards’ software
versions.
4.2.2 Event Messages Screen
The monitor automatically performs a series of built-in tests (BITs) at
start-up and during operation to check sub-systems and modules for
errors. The event messages screen lists the last five event messages, the
time each occurred relative to the unit’s operating hours, and a
recommended service action. There are three event messages and each
has a specific response as follows:
Event Message: Action:
CO
2
board Replace CO
2
board
SpO
2
board Replace SpO
2
board
Flow Replace CO
2
board