INSTALLER INSTRUC
nekos
products have been manufactured in accordance with safety standards and
conforms to the stipulations of current standards in force.
When correctly assembled, installed and used according to the present instructions, they
will not generate any danger for persons, animals or items.
Symbols used in the manual
DANGER
Contents
1. Safety indications ................................
General notes ................................
Notes for functioning
2. Technical data ................................
3. Technical and constructional information
4. ID plate and marking data
5. Instructions for start-up ................................
Standby state ................................
Wait state ................................
Selection of the channel
Storage of the M1 and M2 memory groups
Control of a stored sequence
F1 and F2 Function buttons
6. Battery status indication
7. Environmental protection
8. Recall to main principles of warranty c
9. Declaration of conformity
3
INSTALLER INSTRUCTIONS
products have been manufactured in accordance with safety standards and
conforms to the stipulations of current standards in force.
When correctly assembled, installed and used according to the present instructions, they
will not generate any danger for persons, animals or items.
Symbols used in the manual
This indication draw the attention about potential dangers
for safety and health of peoples and animals.
................................................................................................
................................................................................................
Notes for functioning and use ................................................................
................................................................................................
and constructional information ................................................................
ID plate and marking data ................................................................
................................................................
................................................................................................
................................................................................................
Selection of the channel ................................................................
Storage of the M1 and M2 memory groups ................................
Control of a stored sequence - M1 and M2 Memories ................................
F1 and F2 Function buttons ................................................................
Battery status indication ................................................................
Environmental protection ................................................................
Recall to main principles of warranty certificate ................................
of conformity ................................................................
TIONS
products have been manufactured in accordance with safety standards and
When correctly assembled, installed and used according to the present instructions, they
This indication draw the attention about potential dangers
safety and health of peoples and animals.
..................................... 4
.................................... 4
............................................ 4
......................................... 5
................................ 6
....................................................... 6
............................................................ 6
..................................... 6
........................................... 7
.................................................... 7
....................................................... 7
...................................... 8
............................................... 8
.......................................................... 8
......................................................... 9
...................................................... 9
....................................................... 10
1. Safety indications
General notes
ATTENTION:
Before installing this appliance, ensure all safety
indications have been read carefully and understood in order to prevent
contact with electricity, injury or any other incident.
be conserved for further consultation at a later date
WARNING D
ANGER OF EXPLOSION I
DIFFERENT TYPE OF BA
WITH CURRENT REGULAT
The manufacturer accepts no responsibility for damage to
animals or things incurred by improper use.
Use for any applications other than those indicated must be authorised
by the manufacturer after technical review of the assembly.
Plastic bags, polystyrene, small metal parts such as nails, staples etc should
be placed out of the reach of children as they constitute a potential source of
risk.
The appliance is not intended for use by people (including children) whose
physical, sensory and mental abilities are reduced, or in case of lack of
experience or knowledge; such persons must be supervised to ensure that
they do not play with the appliance.
Do not use solvents or jets of water to wash the appliance. The appliance
should not be submerged in water.
Before using the remote control, check that installed batteries have the
same nature, quality and tension as those indicated on the technical data
label on the appliance.
Run-down batteries do not belong in normal household waste.
disposed of properly.
The batteries must always be replaced with suitable models corresponding
to the specifications provided on the label attached inside the battery
compartment door. Failure to observe this rule may compromise safety and
void the warranty.
Notes for functioning and use
PIK
is a radio transmitter
provided of a receiver with the same code protocol or the same transmission
philosophy.
For further details see chapter “
This product is designed to be used with the manufacturer's original products.
Use with any other products may result in damage or malfunctions.
The initial start-up of the radio remote control should be carried out by a skilled
and qualified person following the manufacturer's instructions.
After removing packaging, check for any damage on the appliance
4
Before installing this appliance, ensure all safety
indications have been read carefully and understood in order to prevent
contact with electricity, injury or any other incident.
be conserved for further consultation at a later date
ANGER OF EXPLOSION IF THE BATTERIES ARE
DIFFERENT TYPE OF BATTERY
.
D
ISPOSE OF THE USED BATTERIES IN COMPLIAN
WITH CURRENT REGULATIONS
The manufacturer accepts no responsibility for damage to
incurred by improper use.
Use for any applications other than those indicated must be authorised
by the manufacturer after technical review of the assembly.
Plastic bags, polystyrene, small metal parts such as nails, staples etc should
be placed out of the reach of children as they constitute a potential source of
The appliance is not intended for use by people (including children) whose
sory and mental abilities are reduced, or in case of lack of
experience or knowledge; such persons must be supervised to ensure that
they do not play with the appliance.
Do not use solvents or jets of water to wash the appliance. The appliance
be submerged in water.
Before using the remote control, check that installed batteries have the
same nature, quality and tension as those indicated on the technical data
label on the appliance.
down batteries do not belong in normal household waste.
disposed of properly.
The batteries must always be replaced with suitable models corresponding
to the specifications provided on the label attached inside the battery
compartment door. Failure to observe this rule may compromise safety and
s for functioning and use
– or simpler a remote control –
with the same code protocol or the same transmission
For further details see chapter “Technical data”.
This product is designed to be used with the manufacturer's original products.
Use with any other products may result in damage or malfunctions.
up of the radio remote control should be carried out by a skilled
n following the manufacturer's instructions.
After removing packaging, check for any damage on the appliance
Before installing this appliance, ensure all safety
indications have been read carefully and understood in order to prevent
contact with electricity, injury or any other incident. The manual should
be conserved for further consultation at a later date.
F THE BATTERIES ARE REPLACED WITH A
ATTERIES IN COMPLIANCE
The manufacturer accepts no responsibility for damage to people,
Use for any applications other than those indicated must be authorised
by the manufacturer after technical review of the assembly.
Plastic bags, polystyrene, small metal parts such as nails, staples etc should
be placed out of the reach of children as they constitute a potential source of
The appliance is not intended for use by people (including children) whose
sory and mental abilities are reduced, or in case of lack of
experience or knowledge; such persons must be supervised to ensure that
Do not use solvents or jets of water to wash the appliance. The appliance
Before using the remote control, check that installed batteries have the
same nature, quality and tension as those indicated on the technical data
down batteries do not belong in normal household waste. They must be
The batteries must always be replaced with suitable models corresponding
to the specifications provided on the label attached inside the battery
compartment door. Failure to observe this rule may compromise safety and
– to command devices
with the same code protocol or the same transmission
This product is designed to be used with the manufacturer's original products.
Use with any other products may result in damage or malfunctions.
up of the radio remote control should be carried out by a skilled
n following the manufacturer's instructions.
After removing packaging, check for any damage on the appliance.
