13
Connection cable not connected
or has a detached wire.
Check all the electrical
connections.
The device is
powered but does
not respond to
commands.
Probable breakage of an
electronic element or the motor.
Contact a qualified technician or
the manufacturer's service
center.
12.3. LED Light signals
If there are any problems during installation or operation, consult the possible causes listed
below:
WITH RED LED
Number
of
Flashes
Type of Error
Possible Solution
1
Overload error:
The electromechanical lock has
detected an overcurrent in the
motor.
Check that there are no obstacles
preventing it from completing its stroke.
Check that it has been installed correctly.
2
Communication error:
Communication between the
electromechanical lock and
actuators is interrupted.
Check the condition of the connection
cables, and repeat the RESET procedure if
necessary.
3
Error in the actuators
Check the error LED on the actuators.
7
Encoder error:
The internal encoder had a
counting error.
Repeat the RESET procedure.
8
Electric power supply error:
The power supply voltage is
outside the allowed range or
unstable.
Check the electrical contacts at the ends of
the lock's cable and ensure that the power
supply voltage is correct.
10
Memory error:
The internal memory write
process failed.
Repeat the RESET procedure.
11
Connection error:
A RESET procedure is being
started with several actuators
that are not compatible with one
another.
Check the type of actuators selected for
the system.
Repeat the RESET procedure.
WITH GREEN LED
LED Status
Meaning
STEADY-ON
Device powered correctly.
The device executed a chain re-entry stroke correctly, completing
the operation by writing to the memory, or is in motion.
FLASHING
Device powered correctly and at the opening stroke-end.
The number of flashes indicates the address number previously
assigned to the device during the RESET procedure.
14
WITH ORANGE LED
LED Status
Meaning
STEADY-ON
Duration < 0.5
seconds
Internal memory write process in progress.
STEADY-ON
RESET Procedure in progress.
FLASHING
RESET Procedure finished correctly.
The number of flashes indicates the address assigned to the
device in a configuration with several devices.
13. ENVIRONMENTAL PROTECTION
All materials used in the manufacture of this appliance are recyclable.
We recommend that the device itself, and any accessories, packaging, etc. be sent to a centre
for ecological recycling as established from laws in force on recycling. The device is mainly
made from the following materials: aluminium, zinc, iron, plastic of various type, cuprum.
Dispose materials in conformity with local regulations about removal.
14. CERTIFICATE OF GUARANTEE
The manufacturer will guarantee good function of the appliance. The manufacturer shall
undertake to replace defective parts due to poor quality materials or manufacturing defects in
accordance with article 1490 of the Civil Code.
The guarantee covers products and individual parts for
2 years
from the date of purchase. The
latter is valid as long as the purchaser possesses proof of purchase and completion of all
agreed conditions of payment.
Guarantee of good function of appliances agreed by the manufacturer implies that the latter
undertakes to repair or replace free of charge and in the shortest period possible any parts that
break while under warranty.
The purchaser is not entitled to any reimbursement for eventual direct or indirect damage or
other expenses incurred. Attempt to repair by personnel unauthorised by the manufacture shall
render the warranty null and invalid.
The warranty does not cover fragile parts or parts subject to natural wear and tear or
corrosion, overload, however temporary etc. The manufacturer will accept no responsibility for
eventual damage incurred by erroneous assembly, manoeuvre or insertion, excessive stress
or inexpert use.
Repairs performed under guarantee are always "
ex factory of the manufacturer
". Respective
transport expenses (out/back) are the responsibility of the purchaser.
