Neilsen CT2818, Оригинальная инструкция, Страница: 8 / 13

action.
8. IMPORTANT GENERAL SAFETY TIPS!
1. The Tool should be unplugged when changing accessories.
2. If you stall the tool, switch it off immediately.
3. Periodically check the tightness of your collet chuck, especially during
prolonged use of the same accessory
4. After use, always disconnect your power tool
5. Do not undertake repair of the power tool your self.
6. Do not leave your tool unattended while switched on.
7. Do not use or store your tool in damp or wet conditions.
9. USEFUL HINTS & TIPS
1. Your rotary tool will become warm after prolonged use and so must be
switched off and allowed to cool down.
2. To ensure smooth running, the spindle should be oiled periodically.
3. Do not apply too much radial pressure to the accessory bits while
polishing, cleaning, sanding or grinding. By doing this you will put a strain on
the spindle and adversely affect the precision of the tool.
4. Always work with a sensitive touch so as not to impede the efficiency of
your mini tool.
5. When drilling metal, always mark the drilling point with a centre punch
first, so that your rotary tool does not slip.
6. Always ensure that you have maximum contact between the accessory
shaft and the collet chuck.
7. Vary the speed on the tool for the work in hand, eg. Low speed for
polishing & cleaning and high speed for engraving
10. PLACING ACCESSORIES INTO THE TOOL
Always switch the tool off first. Hold the locking button at the front of the tool
down and undo the collet chuck (anti-clockwise). Insert the collet that matches
the shaft size of the accessory to be used. Place the collet nut over the collet
and then insert the accessory shaft into the collet chuck ensuring maximum
shaft contact. Then tighten up the collet nut. (DO NOT USE PLIERS).