Neilsen CT2818, Оригинальная инструкция, Страница: 7 / 13


Use the power tool, accessories and cutting tools, etc., in accordance
with these instructions and in the manner intended for the particular type
of power tool, taking into account the working conditions and the work
which needs to be done. Using a power tool in ways for which it was not
intended can lead to potentially hazardous situations.
4.5
Service
Your power tool should be serviced by a qualified specialist using only
standard spare parts. This will ensure that it meets the required safety
standards.
5. SPECIFIC SAFETY WARNINGS
Do not use the tool on light metal with a magnesium content
exceeding 80%, as this type of metal is flammable.

Make sure that the accessories used are suitable for the maximum speed
stated in the technical data. Make sure that the accessories are mounted
according to the instructions.

Only use accessories and adapters supplied by the manufacturer.

Make sure that sparks cannot hit any persons or set flammable materials
alight.

Always wear safety goggles, hearing protection and if necessary other
protective means, such as working gloves, hard hat, etc.
6. MULTIFUNCTION POWER TOOL START-UP
Never start up or stop the tool is the accessory is in contact with the piece to
be worked on. Hold it firmly and press the ON/OFF switch. The tool will run
continuously until the switch is turned to OFF position. The speed can be
adjusted while the tool is running.
7. SPEED ADJUSTMENT
The multifunction power tool is equipped with speed control. Do not change
the speed while the tool is working. The speed switch is located on the rear
of the tool. Turn it to increase or reduce speed. Use the tool at low speed for
polishing and similar operations, but use higher speed for drilling or cutting