Neilsen BDE3500E, Оригинальное руководство пользователя

Страница: 27 / 44

6.2 DC application
1. DC terminals are only for charging 12V battery.
2. Set the air switch at
“OFF” position while charging. On the 12V output terminals, a charge
switch can be connected so the switch can be used for on-and-off purpose.
3. Concerning the automatic type battery with the leads, be sure to disconnect the negative
leads of the battery while charging.

Connect the positive and negative poles of the battery with the positive and negative
poles of DC terminals separately. Do not confuse them, otherwise the battery and
generating set will burn out.

Do not connect the positive pole of the battery with its negative pole, otherwise the
battery damage will result.

Do not connect the positive pole of the DC terminal with its negative pole, otherwise
the generating set damage will result.

When a large capacity battery is charged, excessive current flows, the fuse for the
direct current will burn out.

Do not run the generating set while it is still connected with the battery.

Do not use DC12V and AC at the same time.

Battery exhausts explosive gas. Keep sparks, flames, and cigarettes away from the
battery. To prevent from creating a spark near the battery, always connect the
charging cables to the battery first and only then to the generating set. When
disconnecting, you should disconnect the cables at the generating set first.

Charge the battery at a well-ventilated place.

Before charging, remove the cap from each cell of the battery.

Stop charging if the electrolyte temperature exceed 45
o
C.
CAUTION
CAUTION