29
Trouble-shooting Guide
Problem
Possible cause
Remedy
... if is displayed?
The power supply was briefly inter-
rupted.
Re-activate the electronic timer and
oven control.
... if the hydroclean system control
lamp fails to illuminate after the func-
tion has been activated?
Defective control lamp.
Temperature inside oven cavity is still
too high.
Replacement only by an authorised
expert.
Prior to using the hydroclean
system, the oven must be allowed to
cool completely.
... if the oven suddenly stop functio-
ning.
The electronic timer is set to an auto-
matic timing cycle.
Set electronic timer to operation
without automatic timer:
1.
Reset ON time
?
to
{
:
{{
.
2.
Press the
>
button.
... if after prolonged use, the oven
window panes are soiled from the
inside.
This kind of soiling is normal.
Remove the oven door
and lay
front side down on a soft, clean
base.
Grip the
door glass
near the hinges,
pull up and remove.
Doors with 3 panels:
Disengage
inner door glass
at the
corner pieces and lift it up using, for
example, a pair of frying tongs made
of plastic or wood.
Installing the cleaned glass:
Insert the
inner door glass
and lock
into position.
Press firmly down on the
door glass
until the four clips snap into place.
... if the oven suddenly stops functio-
ning and the electronic timer flashes
{
:
{{
?
The power supply was briefly inter-
rupted.
Reset the time of day.
... if the symbols on the control panel
illuminate, but the Main oven is not
heating up?
The Main oven was locked to pre-
vent unauthorised use (safety off fun-
ction).
Using the function selector, switch
5 x from the hot air
v
position to
conventional
e
and back again.
❑
~ ~ ~
must be displayed.
... if the symbols on the control panel
illuminate, but the Mini oven is not
heating up?
The Mini oven was locked to prevent
unauthorised use (safety off func-
tion).
Using the function selector, switch
5 x from the conventional
e
position
to grill
0
and back again.
❑
~ ~ ~
must be displayed.
... if electronically controlled func-
tions fail?
Energy pulses (e.g. lightning flash).
Reset the relevant functions.
… if –
Å
– is displayed?
The oven is locked (childproof lock).
Rotate the function selector 3x from
the
{
position to
a
. Oven light –
Å
–
goes out.
… if enamelled slide-in parts have
dull, light blotches?
Normal occurrence due to dripping
meat juices.
Not possible.
... if the telescoping extension rails
can no longer be fully pushed
together.
Bearings offset after cleaning.
At first, fully extend the extension
rails, and then push them together.
