Neets QueBec Pro, Руководство по установке

Страница: 9 / 14

Page 9 of 14
Relay Control and Indication
The two test buttons are used to test the built-in relay function.
The test buttons are intended for use during installation to control
functionality of connected devices. The LEDs will indicate if the relay
is activated (green) or not activated (off) during use of the test but-
tons. They will also illuminate when the relays are controlled by the
project in the QueBec Pro.
Be aware that you can activate multiple relays at the same time and
damage connected equipment if not carefull.
VGA and HDMI signal detection
The led indicate if a signal on the input is detected or not. If the led light
is green this indicate that a signal are present.
Power and error indication
The “on” LED will show the current status of the controller.
Green Neets Control – QueBec Pro is on and running
normally
Flashing red The Neets Control – QueBec Pro is in error mode,
se section “Error indication” on page 14 for details
Designed in Denmark
Neets Control - QueBec Pro
on
control
config
2 1
tx
rx
in / out
1 2
in
out
relay signal detect
on
1 2 HDMI VGA
1
3 2
Designed in Denmark
Neets Control - QueBec Pro
on
control
config
2 1
tx
rx
in / out
1 2
in
out
relay signal detect
on
1 2
HDMI VGA
1 3 2
Designed in Denmark
Neets Control - QueBec Pro
on
control
config
2 1
tx
rx
in / out
1 2
in
out
relay signal detect
on
1 2 HDMI VGA
1 3 2