TRANSIT ENTRY | INSTALLATION GUIDE
DIP Switch Settings
20/30
4
DIP SWITCH SETTINGS
The DIP-switches are located behind the service cover. The function of the switches
SW2-1 through SW2-8 is dependent upon the installed firmware. Please refer to the
firmware manual for details.
The switches SW1-1 through SW1-4 are described below.
1 2 3 4 5 6 7 8 1 2
3 4
Figure 20: DIP-switches
Range Beeper On / Off
Enable or disable the internal range beeper. The beeper indicates transponder
identification. The signal strength of the identified transponder determines the
beeping frequency. When the transponder is near to the reader the range beeper
will beep fast.
ON
1 2 3 4
SW1
Range beeper ON
ON
1 2 3 4
SW1
Range beeper OFF
RS232 / RS422 Selection
On-board RS232 or RS422 interface selection.
ON
1 2 3 4
SW1
On-board RS232 interface enabled.
ON
1 2 3 4
SW1
On-board RS422 interface enabled.
Unused SW1-3 And SW1-4
The switches SW1-3 and SW1-4 are reserved for future use. It is recommended to
leave these switches in the ON position.
Note
The on-board RS232 and
RS422 interfaces are both
disabled when the USB
connector is in use or when
the TCP/IP interface board
is installed.
