N550 Bakers Oven | Installation Manual
5 |
P a g e
Figure 1. Fire bricks installation
INSTALLING BAFFLE PLATE
The stove comes with a
10” x 12 ¾” x 6” (250(d) x 325(w) x 150
(h) mm) baffle plate. This rests on
the two lugs welded to the inside front of the firebox and on the brick retainer at the back of the
stove.
Position the baffle plate vertically towards the rear of the firebox with the
4” (
100mm) strip welded
to the baffle at the top facing forward. Bring the top edge towards the front of the stove so that it
slides up and over the two support lugs with the
4” (
100mm) strip located between them. Raise
the lower rear edge of the baffle plate to rest on top of the brick retainer.
With the baffle plate in its correct position, ensure it is pushed all the
way back so that it doesn’t
fall.
INSTALLING TOP AIR CONTROL ROD
A stainless-steel rod with a thread at one end and black knob on the other will have been supplied
in the stove. Pass the threaded end of the rod through the hole near the top front corner on the
left side of the stove. Push the rod through until one can feel it has located the nut on the air slide,
then screw rod until tight. Refer to figure 2. Check that the rod slides freely back and forth.
Figure 2. Top air control rod installation