N550 Bakers Oven | Installation Manual
4 |
P a g e
Before Installation
After unpacking, check that the following parts are included inside the firebox:
•
2 side baffles
•
Handle for top air control
•
Lifter for cook plates
•
Allan key for adjustment of top air
Assembling the Stove
The N550 comes mostly assembled, however some parts may need adjusting / to be added
before firing the stove. It is important that the following components are used ensure compliance.
INSTALLING THE BY-PASS DAMPER
Before installing the flue, the by-pass damper handle must be fitted. The handle is supplied inside
the firebox. Insert the threaded end of the handle into the 10mm hole on left side of stove. Looking
down through the flue spigot locate the threaded end of the handle with the extended nut attached
to the by-pass damper. Screw the handle all the way into the nut until tight.
The position of the handle should be at approximately 11
o’clock
when the damper is open,
and
1 o’clock when the damper is
shut.
DO NOT ALTER THE DAMPER ADJUSTMENT RANGE TO INCREASE FIRING FOR ANY REASON.
INSTALLING FIRE BRICKS
The stove comes with 4 fire bricks
9” x 4 ½”
x 1
½”
(230mm x 115mm x 38mm) and a
19”
(480mm) long brick retainer as well as two triangular bricks 2
”
x 2
¾”
x
10”
(50 x 70 x 250mm) for
the front. Refer to figure 1
Place the four fire bricks upright, up against the rear wall of the firebox. Place the U-shaped
brick retainer over the top of the bricks such that the bricks fit inside the U-section. This will hold
them in place. Place the triangular firebricks at the front of the firebox beneath the door opening.
(Note: the firebricks may already be in place upon arrival of the new appliance.)