Necta Brio 250, Инструкция по установке, эксплуатации и обслуживанию

Страница: 12 / 44

© by NECTA VENDING SOLUTIONS SpA
8
0301 162-00
Fig. 9
- remove the powder and the water funnels, the feeders,
the powder deposit drawers and the mixer rotors from the
mixers (see Fig. 8);
- in order to remove the mixer rotors, with a finger block the
disk fitted on the mixer shaft;
- wash all parts with detergent being sure that all visible
residue and product layers are mechanically removed,
using a brush if necessary.
Fig. 8
1 - Drawer cover
2 - Powder deposit drawer
3 - Powder funnel
4 - Water funnel
5 - Feeder
6 - Mixer rotor
Disinfection should be carried out using chlorine-based
detergents.
- soak all components for approx. 20 minutes in a container
filled with the previously prepared chlorine-based deter-
gent;
- reinstall the feeders and the water funnels;
- reinstall the powder deposit drawers and the powder
funnels after thoroughly drying them.
After reinstalling all parts the following is however
required:
- access "Maintenance" mode to clean the mixer (see
relevant paragraph) and add a few drops of the chlorine-
based detergent in the various funnels.
- After disinfection, thoroughly rinse all components to
ensure that all residue of the solution is removed.
Fig. 10
1 - Container hatch
2 - Cup release springs
3 - Container lid
4 - Lid locking notch
LOADING CUPS
In order to load the machine with cups do as follows:
- disconnect the electricity from the machine;
- release the cup container, pushing the catch lever out-
wards, and tilt it forward;
- ensure that the column rotation knob has the lid locking
notch lining up with the opening on the lid itself (if the
dispenser is empty the positioning will be automatic);
- then, lift the knob and manually rotate the central stacker
clockwise;
- lift the container lid;
- lower the cup container hatch;
- fill the columns with cups ensuring that they are not
forced inside each other;
- the central column must be filled last;
- close the machine and make a test selection.
LOADING AND CLEANING
5 - Column rotation knob
6 - Central stacker
7 - Container catch lever
8 - Cup release button