Necta Vending Solutions SpA Zeta CB Series, Установка - Использование - Обслуживание

Страница: 20 / 40

© by NECTA VENDING SOLUTIONS SpA 56
01 10 126-03
PAYMENT SYSTEMS
Interface with "Executive" coin mechanism
Connect the coin mechanism to the 15-pin molex power
supply connector and to connector CN1 on the control board.
Set the board as described in the "Programming of param-
eters and prices" section.
Set the two minidips (SW2) to OFF position.
Interface with MDB coin mechanism
Connect the coin mechanism to connector CN2 and ener-
gise the board with 24 V ac through connector CN19 using
the special cable. Set the board as described in the
"Programming of parameters and prices" section.
Set the two minidips (SW2) to ON position.
Interface with 24 Vvalidator
The validator must be connected to connector CN5 on the
board (see Fig. 27). Set the board as described in the
"Programming of parameters and prices" section.
Free vend for all selections
Place minidip 5 into position “ON”.
MINIDIP FUNCTIONS
Each of the 6 minidip (SW1), when moved to position "ON",
activates one of functions indicated below.
The two SW2 minidips have the following functions:
1-2 ON = payment system MDB
1-2 OFF = payment system Executive
1 - ON = Programming of parameters and sales prices
2 - ON = Reading on the display the stored data
3 - ON = Not used
4 - ON = Total sales display
5 - ON = Free vend
6 - ON = Motor reset
Motor reset
When one or more selections are blocked and the motor
cams are out of position, placing minidip 6 into position
"ON" automatically resets all blocked motors.
When a selection is blocked, the corresponding button is
illuminated.
When pressing the illuminated button, the display indicates
if the cause of the blockage is an empty module
and if the cause is a problem connected with the
motor or with the micro-switch of that column.
Instant display of total sales
Placing minidip 4 into position "ON" causes the total sales
information to be shown on the display, thus skipping the
normal "data" procedure. After storing this value, minidip 4
must be placed back to position "OFF".
Automatically unloading the columns
Simultaneously placing minidip 4 and 6 into position "ON"
enables the function used to automatically unload the
columns.
After closing the door the message
will be
displayed; pressing the button of the selection to be
emptied causes the release motor to be activated at
intervals of five seconds and up to 30 consecutive selec-
tions maximum.
The motor will continue for other four selections after the
signal of "empty" condition.
The automatic unload function can be interrupted by
pressing any button during the 5 second interval between
two releases.
PROGRAMMING OF PARAMETERS
AND PRICES
Place minidip 1 into position "ON".
The indication
will be displayed.
Now the last four selection buttons are illuminated and are
given the following functions:
Fig. 28
BUTTON FUNCTION
Decrease value
Increase value
Store data unit and/or skip to the
next step
Enter/exit programming mode
Reset data (read only mode)
Interface with 24 V validator
No. of selections 1 to 10
Executive Interface
Access program
Enter
Increase
SELECTION BUTTONS
Decrease
MDB interface
COGES Interface
Price Holding interface
U-key Interface