Necta Vending Solutions SpA Zeta CB Series, Установка - Использование - Обслуживание

Страница: 15 / 40

5 1
© by NECTA VENDING SOLUTIONS SpA 01 10 126-03
Fig. 17
1 - Rotor
2 - Insert
3 - Motor mounting screws
4 - Slider
5 - Fixing points for insert
6 - Anti-theft plates for cans
Glass bottles can be dispensed only from single
columns.
To adjust a column for dispensing a certain product, the
type and position of the following elements must be checked:
- rotor insert and side spacer, according to the product
diameter;
- product side support and motor cam, according to the
number of rows and to the product height;
- anti-friction elements and column backing, according to
the number of rows and to the product height;
- if the bottles have a long tapered neck, the positioning
of the bottle guides;
- for cans only, correct position of anti-theft plates.
ROTOR INSERT AND SIDE SPACERS
According to the diameter the appropriate rotor insert and
side spacers must be fitted.
The side spacer can be identified by the its dimension (see
Fig. 16).
Rotor inserts and side spacers are available for the follow-
ing diameters:
62-63-64 mm.
65-66-67 mm.
68-69-70 mm.
Fig. 16
1 - 62-63-64 mm thickness
2 - 65-66-67 mm thickness
3 - 68-69-70 mm thickness
4 - Short adapting plate
5 - Long adapting plate
The rotor insert can be identified by the dispensed product
diameter printed on the element.
To install or replace the rotor insert and the spacers it is
advisable to remove the rotor from the machine, proceeding
as follows:
- undo the screws securing the release motor and extract
the assembly;
- push and extract the insert from the rotor;
- replace the insert and apply pressure to fit it into the
rotor, ensuring that it is properly secured in all points;
- to adjust the rotor for dispensing cans in four rows, it
is necessary to insert three anti-theft plates into the
special slots (see Fig. 17). The plates stop the cans
from sliding in the rotor when this is partially empty.
The plates must inserted into the slots B-D-E for 250
cc cans and into the slots A-C-E for 330 and 355 cc
cans.
There is no need for inserts or side spacers for products
with 71-72-73 mm diameter.
To dispense 62-mm diameter glass bottles from single
columns, it may be necessary to fit adapting plates as
indicated in the figure.
- insert the new spacer in the special slots located on
the left end of the column.
Fig. 18
1 - Baffle
2 - Spacers
3 - Spacer support bracket
4 - Product side support