NEC VERSA FXI, Инструкция по обслуживанию и справочник

Страница: 22 / 101

System Configuration and Setup 2-3
Connecting the AC Adapter
Note
The AC power cable type that your system uses depends on the country where you are
using it. Contact the local dealer to purchase the correct power cable.
Connect the AC adapter as follows:
1.
Connect the AC adapter cable to the power port on the left side of your NEC Versa.
2.
Plug one end of the AC power cable into the AC adapter and the other end into a properly
grounded 120- or 240-volt, 50- or 60-Hz wall outlet.
Connecting the AC adapter
A – Adapter Cable C – AC Adapter
B – AC Power Port D – Power Cable
Do not cover or place objects on the AC adapter. Keeping the adapter
clear of objects lets the adapter cool properly during use.
Only use the AC adapter that comes with your NEC Versa FXi. Although other adapters look
similar, using them can damage your system.
Powering On Your System
Power on the system as follows:
1. Locate the latch on the front of the LCD panel, slide it to the right, and raise the panel.
2. Locate the Power button and slide it to the right to turn on system power.
Note
When powering on your NEC Versa running the Windows 2000 operating system, you
may encounter a warning message suggesting that a problem exists with the hibernation file on
your system. The warning message is inaccurate. To disable this message, simply enable
hibernate support. See the section "Windows 2000 Hibernate," in Chapter 3, for details about
enabling hibernate support.