2-2 Setup and Operation
2.
Plug one end of the AC power cable into the AC adapter and the other end into a
properly grounded 120- or 240-volt wall outlet.
NOTE
Do not cover or place objects on the AC
adapter. This allows heat to dissipate properly.
3.
Ensure that all connections are properly seated and secure.
!
CAUTION
This equipment uses an ungrounded power cable. Replace the cord
if it becomes damaged. U.S. and Canadian replacement cords must
be UL-approved (CSA certified in Canada) type SPT-2, 18 AWG,
2-conductor cord with a permanently attached NEMA type 5-15P
plug at one end, and a permanently attached connector body on the
other. Cord length may not exceed 15 feet. Outside the U.S. and
Canada the cord must be rated for at least 250VAC at 10 amps, and
must indicate international safety agency approval. The plug must
be a type appropriate for the country where it is used.
Obtain replacement cords at an authorized service center. The re-
placement must be of the same type and voltage rating as the origi-
nal cord.
4.
Slide the Power button to the right to power on the computer.
Figure 2-2 Powering on the System
